Durite 0-852-04 2/24V Solid State Battery Guard - 40A
- 40 amp solid state battery guard, with provision for external on/off switch,
- l 76 x w 78 x h 33mm.
- 12/24 volt.
- Protected to IP65.
- ECE and CE approved.
12/24 volt, solid state battery guard, monitors the battery voltage and disconnect load when the battery voltage reaches a pre-determined level. The voltage level at which the device operates to disconnect or reconnect the load to the battery can be set to one of 10 different programmes by the installer using a simple bridge and integral LED indicator. The unit also has provisions for an external on/off switch and an alarm circuit to power an audio and/or visual indicator to warn of imminent disconnect, allowing the operator 50 secs to rectify the situation before disconnecting. A 10 second delay is built in prior to an alarm, to prevent spurious warnings. The alarm circuit is limited to 500mA maximum, if a higher current is required a relay with a diode must be used, 0-727-14 for 12v and 0-727-26 for 24v. Quiescent current is below 10mA. Appropriate terminals and insulating covers are provided.